prinz filter temp/pressure sender data wanted
Posted: Sun Dec 02, 2018 6:58 am
searching for some basic data about the resistance curves given by the bosch 0281002576 combination fuel temp/ pressure sender unit found on top of the Prinz filter unit
a fair bet to expect a delco curve for the temperature.. but is there any sure place to find out? also the inbuilt map sensor? 3 /4/5 bar?
changing out a profire ecu on a FC rx7 with 8 prinz injectors for an adaptronic m6000 / which has fuel density modelling in its Ve tune .. the profire has suffered repeated driver hardware failure and is limited driving the rx7 ignition
the rx7 is already LPG compliant with prinz vapour system
thanks in advance
a fair bet to expect a delco curve for the temperature.. but is there any sure place to find out? also the inbuilt map sensor? 3 /4/5 bar?
changing out a profire ecu on a FC rx7 with 8 prinz injectors for an adaptronic m6000 / which has fuel density modelling in its Ve tune .. the profire has suffered repeated driver hardware failure and is limited driving the rx7 ignition
the rx7 is already LPG compliant with prinz vapour system
thanks in advance