It's funny how the venerable Holley has almost gone extict. Try as I might, there are no good used examples to be found in my area.
Does anyone have a line on where to get a good used square bore base plate, or carb for that matter? I have found plenty of new pieces online, but they are almost as expensive as a complete carb.
I believe a 750 base plate with 1 11/16" bores is most desireable since it is closest to the size of the Impco 425.
Thanks in advance....
Holley Base Plate
Holley Base Plate
"I looked around, a lousy candle's all I found..."
Found one!
A friend came through with a Holley 600 cfm cheap enough that I snatched it up. For future reference, it is an 1850-3 model 4160 with vac. secondaries. The bores are 1 9/16". They are slightly smaller than the bores on the impco, but look to be just fine. The 1 11/16 bores on a 750 cfm base are probably a closer match, though.
Frank & Franz, Look for a question I have in the tech topics about the secondary acctuation. Thx.
Frank & Franz, Look for a question I have in the tech topics about the secondary acctuation. Thx.
"I looked around, a lousy candle's all I found..."