Forum Logo

Look here for announcements. Please make comments and ask questions about the board here too.
Frank
Site Admin
Posts: 886
Joined: Wed Feb 25, 2004 2:17 pm
Location: Stevensville, ON
Contact:

Re: Forum Logo

Post by Frank »

I changed the width from 1920px to 99%. How does it work now?

storm
Posts: 665
Joined: Wed Jan 10, 2007 10:10 pm
Location: NSW, Australia

Re: Forum Logo

Post by storm »

It's working well for me, thanks.
Every job is a self-portrait of the person who did it. Autograph your work with excellence.

Fuel flow requirements calculations viewtopic.php?f=5&t=1638

BigBlockMopar
Posts: 385
Joined: Sun Sep 02, 2007 3:29 pm
Location: Netherlands
Contact:

Re: Forum Logo

Post by BigBlockMopar »

You can edit which file(type) to show in the header by editing the appropiate template file.
But these days you can even install a forum-extension that handles this more easier.

You can't "just" convert a bitmap-file to a vector SVG-file normally.
Since I made the logo in Photoshop originally, I just remade it in Adobe illustrator and saved it as an SVG-file, including the shadow behind it which should work better now.
Attachments
RasoEnterprises-logo.svg.zip
(209.79 KiB) Downloaded 7 times
https://www.bigblockmopar.com
'73 Dodge Dart - 360ci - 11.3:1cr
MegaSquirt + HEI 7-pin timing control - Edelbrock AirGap - Cold Air Intake
IMPCO E / 425 mixer - A518 OD-trans - 3.55 gears - 225/50/17" tires.

Frank
Site Admin
Posts: 886
Joined: Wed Feb 25, 2004 2:17 pm
Location: Stevensville, ON
Contact:

Re: Forum Logo

Post by Frank »

Well, that looks a lot better. Thanks!

Were the proportions 3:1?

BigBlockMopar
Posts: 385
Joined: Sun Sep 02, 2007 3:29 pm
Location: Netherlands
Contact:

Re: Forum Logo

Post by BigBlockMopar »

I didn't note or pay attention to proportions. Just closely remade the logo from the Photoshop-file I had.
https://www.bigblockmopar.com
'73 Dodge Dart - 360ci - 11.3:1cr
MegaSquirt + HEI 7-pin timing control - Edelbrock AirGap - Cold Air Intake
IMPCO E / 425 mixer - A518 OD-trans - 3.55 gears - 225/50/17" tires.

Frank
Site Admin
Posts: 886
Joined: Wed Feb 25, 2004 2:17 pm
Location: Stevensville, ON
Contact:

Re: Forum Logo

Post by Frank »

I resized your revised file to the old pixel size but it didn't fit right so I adjusted the property in the common file to a 3:1 proportion which seems look good now. Thanks again!

Post Reply